|
Post by pezerologo on May 20, 2015 13:43:22 GMT
Hi everyone !! I'll tell you as we have finally made the cabinet for Fishroom I am preparing for our new house. The design did between Gums and I told him what I wanted masomenos and showed me a way to make very highly resistant structures. Not much mystery, plank of 2 cm and using battens in the middle make a sandwich of 5 cm thickness screwing each other, making the different parts as necessary. Each piece is screwed to the wall and the set so it is very consistent. After use putty to the joints between wood and Aquaplast above even lack's take a little more and then polish it a bit, I hope these weeks to start painting. Bitxo is the manager of the electrical part, dividing electrical outlets for different purposes, some light sockets and others to equipment, like I always say bitxo not cease to amaze me, you're a crack: ok: It is divided into two parts and various heights, the ground floor will house an aquarium of 150 liters and another of 100. The following shelf a part 4 20 l tank and the other 4 of 40 liters. In the next, 10 liters and one of 18 turtletank shaped. There are many liter but keeps many distinct species and aquariums. When the Expo ends began to fill with Aquariums. I'll show you pictures of the process and will understand much better explanation. Detail Wood Sandwich The base already finished Gums finishing second shelf height This rises !!!! side raised! And another height for the furniture !! I hope your opinions and any suggestions or ideas on the subject. Currently there are not many mounted aquariums, but again are beginning to multiply .... Gr3tings !!!
|
|